49 lines
2.6 KiB
Markdown
49 lines
2.6 KiB
Markdown
# Universal K80 Cooling
|
|
|
|
This is a Linux cooling control software, which uses an Arduino Uno, PWM fan, and Python 3. It was designed for use with a Tesla K80, but should work with any NVIDIA GPU.
|
|
|
|
This will determine the speed your fan (connected to your Arduino) should run at based on the highest temperature
|
|
between your GPUs, then will send that speed to your Arduino.
|
|
|
|
Make sure to set the port in the .py file you use!
|
|
|
|
---
|
|
|
|
### How to use
|
|
1. Connect the Arduino to the fan according to this diagram:
|
|
|
|
2. **Set the port variable**
|
|
1. Instructions for finding the port are in the Python code.
|
|
3. Upload `Arduino/rx_speed.ino` to your Arduino Uno, then run `Python/tx_speed.py`.
|
|
1. Make sure not to run the Python file until the Arduino sketch is done uploading! It should only take a few seconds.
|
|
5. Revel in your success!
|
|
1. If you plan to use this constantly, make sure to create a service that starts the Python code on boot.
|
|
|
|
### My setup
|
|
I use [this](https://www.thingiverse.com/thing:4960323) 3D-printed fan adapter for my Tesla K80; I highly recommend it.
|
|
|
|
Also, I use [this](https://www.amazon.com/8025-DS08025R12U-0-7A-4Wire-Cooler/dp/B08PYLMGVM) fan. I wouldn't recommend buying it, though. I just use it because it's the most powerful fan I already had. It's also pretty loud.
|
|
|
|
In the long-term, I'm planning to build my own front cover for my PC case (a Corsair 175R), and will have a spot for my
|
|
Arduino and wiring in it.
|
|
|
|
Pictures will be added later once my setup is complete. Don't expect it to happen anytime soon, though.
|
|
|
|
---
|
|
|
|
### Notes and Limitations:
|
|
- This currently **only supports NVIDIA GPUs**
|
|
- This currently **only supports normal PWM**, not delta PWM
|
|
- You may need to change some variables in the Arduino code depending on your fan's specifications.
|
|
- Try looking up a datasheet
|
|
- This was designed for an Arduino Uno, and should work on one. I don't know about running it on anything else, though.
|
|
- I'm busy, so a lot of the files are probably still broken. However, the main stuff is working.
|
|
|
|
---
|
|
|
|
### Resources I used
|
|
- Python-Arduino communications library - [pySerialTransfer](https://github.com/PowerBroker2/pySerialTransfer)
|
|
- Thanks for the help figuring this out, [PowerBroker2](https://github.com/PowerBroker2)!
|
|
- Arduino PWM fan control - [25 kHz 4 Pin PWM Fan Control with Arduino Uno](https://create.arduino.cc/projecthub/tylerpeppy/25-khz-4-pin-pwm-fan-control-with-arduino-uno-3005a1)
|
|
- This is the basis of my arduino-fan diagram
|
|
- See NVIDIA GPU temperatures - [GPUtil](https://pypi.org/project/GPUtil/)
|